Corvette Rotors, Including SCCA T1 HARBAR Racing Brake Parts.
Rotor
The disk rotor is made of iron with highly machined surfaces where the brake pads contact it. Just as the brake pads wear out over time, the rotor also undergoes some wear, usually in the form of ridges and groves where the brake pad rubs against it. This wear pattern exactly matches the wear pattern of the pads as they seat themselves to the rotor. When the pads are replaced, the rotor must be machined smooth to allow the new pads to have an even contact surface to work with. Only a small amount of material can be machined off of a rotor before it becomes unusable and must be replaced. A minimum thickness measurement is stamped on every rotor and the technician doing the brake job will measure the rotor before and after machining it to make sure it doesn't go below the legal minimum. If a rotor is cut below the minimum, it will not be able to handle the high heat that brakes normally generate. This will cause the brakes to "fade," greatly reducing their effectiveness to a point where you may not be able to stop!Â
01 DBA 4000 Series Slotted Front Rotors C6 & Z06 Corvette Front Pair
02 C5/C6 Corvette SCCA T1 Hardbar, Replacement Competition AP Racing Brake Rotor / Disc Ring
03 DBA 4000 Series Slotted Front Rotors C6 & Z06 Corvette Rear Pair
04 AP Racing J Hook Competition Disc Replacment Ring (325x32mm)- Left Hand, Corvette and others
05 2005-2013 C6 Corvette Brake Rotor Hub Covers
06 2005-2013 C6 Z51 Corvette Baer Decela Rotors Brake Package, 4 Rotors
|
WARNING: Cancer and Reproductive Harm - www.P65warnings.ca.gov
All Content COPYRIGHT 2000-2020 C6 Performance and Loaded Commerce. All Rights Reserved.